Panasonic kw9m User Manual

Also see for KW9M Eco-Power Meter: User manual User manual Installation instructions

Contents

KW9M Eco-POWER METER45Data register Name Unit Kind of data Range R/WDT05040DT05041Export powerconversion value (1) 0.01 Unsigned 32bit 0 to 999999999 RDT05042DT05043Export powerconversion value (2) 0.01 Unsigned 32bit 0 to 999999999 RDT05044DT05045Export powerconversion value (3) 0.01 Unsigned 32bit 0 to 999999999 RDT05046DT05047Total export powerconversion value 0.01 Unsigned 32bit 0 to 2999999997 RDT05090DT05091 Conversion value (1) 0.01 Unsigned 32bit 0 to 999999999 RDT05092DT05093 Conversion value (2) 0.01 Unsigned 32bit 0 to 999999999 RDT05094DT05095 Conversion value (3) 0.01 Unsigned 32bit 0 to 999999999 RDT05096DT05097 Total conversion value 0.01 Unsigned 32bit 0 to 2999999997 R* ’Range’ is not the measurement range, it shows the data range.Note1) R: Read W: Write2) Data register except specified is 0.3) If each setting value is wrote by communication, it memories to internal EEP-ROM at the sametime. Therefore, change setting frequently makes EEP-ROM’s life short. Avoid to usage like this.4) Write a data within the range when you write it.6.3.3 Error Codes◇Basic procedure errorsError code Error name Explanation40H Bcc error ・A Bcc error occurred in the command data.41H Format error ・A command message was sent that does not fit the transmissionformat.42H No support error ・A command was sent that is not supported.43H Procedure error ・Delimiter with multiple frames was sent.・The response shall be multiple frames.◇Application errorError code Error name Explanation60H Parameter error ・The data code is not “D”.61H Data error・Word No. is specified without decimal.（0000F etc.）・The starting word No. is bigger than the ending word No.・Writing data has a code that is not hexadecimal.62H Registration error・Too many registrations have been entered (more than 17).・“MD” command was sent when some registration has been exist.・ “MG” command was sent when registration has not beenentered.◇Self-diagnostic errorError code Error name Explanation45H Operation error ・At “WD” command, writing data is exceeded the range of dataregister.