Panasonic th-32ef1e Operating Instructions Manual

Contents

19EnglishBasic format for control dataThe transmission of control data from the computerstarts with a STX signal, followed by the command, theparameters, and lastly an ETX signal in that order. Ifthere are no parameters, then the parameter signal doesnot need to be sent.STX C1 C2 C3 P1 P2 P3 P4: P5 ETXStart(02h)3-character command(3 bytes)ColonParameter(s)End(03h)CommandCommand Parameter Control detailsPON None Power ONPOF None Power OFFAVL *** Volume 000 ‒ 100AMT 0 Audio MUTE OFF1 Audio MUTE ONIMS None Input select (toggle)HM1 HDMI 1 input(HDMI1)HM2 HDMI 2 input(HDMI2)DV1 DVI-D IN input(DVI-D)PC1 PC IN input (PC)VD1 VIDEO input(VIDEO)UD1 USB input (USB)DAM None Screen mode select(toggle)ZOOM Zoom1FULL 16:9NORM 4:3ZOM2 Zoom2Note● If multiple commands are transmitted, be sure towait for the response for the first command to comefrom this unit before sending the next command.When sending a command which does not requireparameter, a colon (:) is not needed.● If an incorrect command is sent by mistake, thisunit will send an “ER401” command back to thecomputer.● In Standby condition (power OFF with remotecontrol), the unit responds to PON command only.● Consult your local Panasonic dealer for detailinstructions on command usage.For more details, visit the following web site.http://panasonic.net/prodisplays/IR IN/IR OUT terminal connectionConnect the mini plug (M3) cable from the IR OUTterminal of the first display to the IR IN terminal of thesecond display.The infrared signal of the first display is sent to thesecond display.In this case, the IR (infrared ray reception on the remotecontrol sensor) on the second display does not operate.Repeating the above connections enables the daisychain connection.Note● Connection cables are not supplied with this unit.● Daisy chain connection is possible only between thedisplays of the same series.Stereo mini plug (M3) cable (commercially available)First displaySecond displayThird display