English56Power on screen delayYou can set the power-on delay time of the displays toreduce the power load, when you press On / Off button> to turn on the multiple displays that areset together.Set each display’s setting individually.[Off]:The display will be turned on at the same time as is pressed.[Auto]:Sets the delay time automatically according to thenumber set for [Display ID].The delay time is determined by multiplying[Display ID] × 0.3 seconds.Example:When [Display ID] is 3 → 0.9 seconds1 ‒ 30:Set the power-on delay time (second).After pressing ,the display will be powered on with time delaydepending on this setting.Note● While this function is working, the power indicator isblinking green.● This function also works when the power recoversfrom failure or after plugging off and in again thepower cord.Clock displaySets to display / hide the clock.[Off]:Hides the clock.[On]:Displays the clock.Note● The clock is displayed at the lower left of the screenwhen button is pressed.● When current date and time is not set, the clock isnot displayed even when [Clock display] is [On]. (seepage 47)Power on message(No activity poweroff)Sets to show/hide [No activity power off] precautions atthe time the unit is turned on.[On]:The warning precautions are shown at the time ofpower ON.[Off]:The warning precautions are not shown at the timeof power ON.Note● This setting is enabled only when [No activity poweroff] is [Enable] (see page 45).Power on message(Powermanagement)Whether to show/hide an information message that tellsthe power has been turned off by “Power management”function when the power is set to [On].[On]:The information is shown at the time of power [On].[Off]:The information is not shown at the time of power[On].Note● This setting is enabled only when “Powermanagement” function is [On] (see page 43).InitializationWhen both main unit buttons and remote control buttonsare disabled due to the [Button lock], [Controller userlevel] and [Controller ID function] settings, set all thevalues [Off] so that all the buttons are enabled again.Press <- (Unit)> together with and hold for more than 5 seconds.[Shipping] is displayed and the lock is released whenit disappears.ShippingYES NO● Settings for [Button lock], [Controller user level]and [Controller ID function] will be back to [Off].
