Panasonic th-32ef1e Operating Instructions Manual

Contents

55EnglishController ID functionEnables/Disables the ID remote control function.To operate this function, please purchase ID remotecontroller sold separately. (see page 78)[Off]:Disables the ID remote control function. (Can beoperated as normal remote control.)[On]:Enables the ID remote control function.Effective on switching to [On].Note● To use the ID remote control function, setting IDnumbers both for the remote control and for thedisplay unit is required.For ID number setting for the remote controland display unit, see page 78 and [Display ID]respectively.● About how to reset the settings to defaults:“Initialization” (see page 56)Serial ID functionSet to control external control with the PC connected toSERIAL terminal according to the Display’s ID number(Panel ID).[Off]:Disables external control by the ID.[On]:Enables the external control by the ID.LAN control protocolSelect the LAN control protocol.[Protocol 1]:Control with the Panasonic Display sequence.[Protocol 2]:Control with the sequence that compatible withPanasonic Projector.Note● For PJLink and WEB browser control, the operation ispossible regardless of the setting.● When performing the command control with TCP/IP,select [Protocol 1].● When operating the “Early Warning Software” or“Multi Monitoring & Control Software”, select [Protocol2].Information timingSet up the informing manner for no signal ortemperature rising.During RS-232C controls:Warning or error message sent on the displayautomatically.During LAN controls:Acquire the warning or error message from thedisplay.1 Select the item with .Select the set point with .Information timingNo signal warningNo signal warning timingNo signal error timingNo signal errorOn5minOn10min[No signal warning]When set to [On], the display sends out the no signalwarning.[No signal warning timing]Set up the detecting time for no signal warning.(Range: 01 ‒ 60, Interval: 1 minute)[No signal error]When set to [On], the display sends out the no signalerror.[No signal error timing]Set up the detecting time for no signal error.(Range: 01 ‒ 90, Interval: 1 minute)● The warning of [No signal warning] and the errorof [No signal error] are not sent when the no signalstate is detected through any of the followingfunctions:[No signal power off], [HDMI1 power management],[HDMI2 power management], [DVI-D powermanagement], [PC power management] (see page43)● If there is no signal when [PC IN] is input, [PCpower management] is activated first and theDisplay enters the standby mode.Setting Example:[No signal warning timing]: 5 minutes[No signal error timing]: 10 minutes[PC power management]: [On] (60 seconds)Note● The [No signal error timing] cannot be set shorterthan [No signal warning timing].● With the USB input, the unit determines videosignals are interrupted by judging the USB memoryis not connected to the USB terminal.