Panasonic th-32ef1e Operating Instructions Manual

Contents

English8Do not reverse the polarity (+ and -) of the batterywhen inserting.• Mishandling the battery may cause its explosionor leakage, resulting in fire, injury or damage tosurrounding properties.• Insert the battery correctly as instructed. (see page11)Remove the batteries from the remote controltransmitter when not using for a long period of time.• The battery may leak, heat, ignite or burst, resulting infire or damage to surrounding properties.Do not burn or breakup batteries.• Batteries must not be exposed to excessive heat suchas sunshine, fire or the like.Do not turn the Display upside down.Do not position the unit with its display panel facingupright.Precautions for useCautions when installingDo not set up the Display outdoors.• The Display is designed for indoor use.Environmental temperature to use this unit• When using the unit where it is below 1 400 m (4 593ft) above sea level: 0 °C to 40 °C (32 °F to 104 °F)• When using the unit at high altitudes (1 400 m (4 593ft) and higher and below 2 800 m (9 186 ft) above sealevel): 0 °C to 35 °C (32 °F to 95 °F)Do not install the unit where it is 2 800 m (9 186 ft)and higher above sea level.• Failure to do so may shorten the life of the internalparts and result in malfunctions.Required space for ventilationWhen using the pedestal (optional accessory), leavea space of 10 cm (3 15/16 ”) or more at the top, left andright, and 5 cm (1 31/32 ”) or more at the rear, and alsokeep the space between the bottom of the display andthe floor surface.If using some other setting-up method (wall-hanging,etc.), follow the manual of it. (If there is no specificindication of installation dimension in the installationmanual, leave a space of 10 cm (3 15/16 ”) or more at thetop, bottom, left and right, and 5 cm (1 31/32 ”) or more atthe rear.)Minimum distance:aa baa: 10 cm(3 15/16 ”)b: 5 cm(1 31/32 ”)About the screws used when using a wall hangingbracket that conforms to VESA standardsInchmodelScrew pitch forinstallationDepth ofscrewholeScrew(quantity)32 100 mm × 100 mm 10 mm M4 (4)Be careful of the movable structure of the powerindicator and remote control sensor.• As factory default, the power indicator and remotecontrol sensor are stored in the main unit. For normaluse, pull out the remote control sensor from the edgeside of the main unit by operating the lever on therear panel. Depending on the setup condition such aswhen using the multi display, store the remote controlsensor in the main unit. (see page 22)Do not grab the liquid crystal panel.• Do not forcibly press the liquid crystal panel, or pushit with a pointed object. Applying a strong force tothe liquid crystal panel will cause unevenness of thescreen display, resulting in malfunction.