English48■ [LAN setup]Detailed network settings for the LAN established viathe LAN terminal of the Display can be configured.Select [LAN setup] with and press .192.168. 0. 8255.255.255. 0192.168. 0. 11024--:--:--:--:--:--LAN setupSaveDHCP OffIP addressSubnet maskGatewayPort[DHCP], [IP address], [Subnet mask], [Gateway]Press to set [On] / [Off] of [DHCP] and press.When [Off] is selected, IP address and other settingscan be set manually.[DHCP]:(DHCP client function)[On]:Obtains an IP address automatically when aDHCP server exists in the network the Display isgoing to be connected.[Off]:When a DHCP server does not exist in thenetwork the Display is going to be connected,set [IP address], [Subnet mask] and [Gateway]manually.[IP address]:(IP address display and setting)Enter an IP address when DHCP server is notused.[Subnet mask]:(Subnet mask display and setting)Enter a Subnet mask when DHCP server is notused.[Gateway]:(Gateway address display and setting)Enter a gateway address when DHCP server is notused.Note● When [DHCP] is set to [On], the IP address, etc. willbe displayed in grey.Entering numbersI192.168. 0. 8IP address1. Select the address and press .2. Select digits with .3. Change numbers with .4. Press .You can cancel the change by pressing.Select [Save] and press .Save the current network Setup.Note● To use a DHCP server, make sure the DHCPserver is started.● Contact your network administrator for details on[IP address], [Subnet mask] and [Gateway].● Shipping condition[DHCP]: Off[IP address]: 192.168.0.8[Subnet mask]: 255.255.255.0[Gateway]: 192.168.0.1[Port]Set the port number used for command control.Select [Port] and press to set the number.● The available setting range is 1024 ‒ 65535.● Entering numbers (see page 48)Note● When the PJLink protocol is used, the port setting isnot necessary.■ [Network status]Checks the current Network settings status.192. 168. 0. 1255. 255. 255. 0192. 168. 0. 812:34:56:78:9A:BCNetwork statusDHCPIP addressSubnet maskGatewayMAC addressOff■ [AMX D. D.]Set whether to allow the Display to be detected by AMXDevice Discovery.[On]:Enables detection by AMX Device Discovery.[Off]:Disables detection by AMX Device Discovery.● For more details, visit the following web site.http://www.amx.com/■ [Crestron Connected™]When this function is set to [On], the Display canbe monitored or controlled via the network usingequipment and application software of CrestronElectronics, Inc.This Display supports the following application softwarefrom Crestron Electronics, Inc.• RoomView ® Express• Fusion RV ®• RoomView ® Server Edition
