4.Wired network setup (applicable to wirednetwork models)In case printers support wired network printing, they can be connected to network to controlprinter to print in wired network mode.4.1.Set IP AddressDHCP automatic setting function is enabled by default on the printer.1. Connect the printer to the network through a network cable and complete the startuppreparation work.2.The printer will receive the IP address assigned by server automatically. It may take serverminutes to receive IP address under the influence of network environment.Note： • If DHCP server fails to assign IP address automatically, the printer will getthe link-local address assigned by printer automatically: 169.254.xxx.xxx.4.1.2.Manual Setting4.1.1.Automatic SettingYou can check the IP address of printer by printing "Network setup page" out (please refer toChapter 12.4 for printing method) or check network information by viewing the control panelof printer (please refer to Chapter 12.3 for viewing methods). If the IP address is not listed,please check network environment and then try again after waiting for several minutes.To set up IP address for printer through the control panel of printer manually, please refer toChapter 12.2 for details.To set up IP address for printer through the embedded Web server manually, please refer toChapter 6.2.1 for details.The IP address of the printer may be automatically obtained through DHCP function or setmanually.32
