Pantum M6700 Series User Manual

Also see for M6700 Series: Faq Installation manual User guide Faq Faq

Contents

Pantum M6700 Series User Manual Manual pdf 56 page image

6.2.1.2.IPv6 setup1.Turn on printer power to connect printer to network.4.Tick “Enable IPv6 protocol” and “Enable DHCPv6” (ticked by default) and then click “Apply”.You can refresh the browser and view the “IPv6 Local Link Address” and “Stateful Address”in “Wired IP Configuration” interface.Note：The printer supports using the following IPv6 addresses for networkprinting and management(please refer to Chapter 12.4 and print “NetConf Pg”IPv6 local-link address: local IPv6 address set up by oneself(addresses beginning with FE80).• Stateful address: IPv6 address set up by DHCPv6 server(if there is no DHCPv6 server in network, the “Stateful Address”cannot be assigned).• Stateless address: IPv6 address set up by network router automatically.6.2.2.Wireless setup6.2.2.1.Wireless network1.Click “Settings” – “Network settings” – “Wireless setup” – “Wireless Network”.1)The wireless network is defaulted on; please select “Off” option box and then click“Apply” if it needs to be turned off.2) If you need to set up wireless network, please click the SSID of access point (wirelessrouter) in search list, input secret key and click “Apply”.•You can set up the wireless network, wireless IP setup, Wi-Fi Direct and WPS via wirelesssetup page. Before setup, please log in the embedded Web server(please refer to Chapter 6.1 for login method).6.2.2.2.Wireless IP setupOnly when the wireless network of printer is turned on, the Wireless IP Configuration can bedisplayed on Web server.1.Click “Settings” – “Network settings” – “Wireless setup” – “Wireless IP Configuration”.1) DHCPv4 is ticked by default. If IP address needs to be set up manually, please cancelthe DHCPv4 checkbox ticked and input the “IPv4 Address”, “Subnet Mask” and “GatewayAddress” that you need to set up and then click “Apply”.6.2.2.3.WPS setup1.Click “Settings” – “Network settings” – “Wireless setup” – “WPS”.1) Select the “WPS Startup Method” you need, and then click “Apply” and operateaccording to page prompt.2.Log in the embedded Web server (please refer to Chapter 6.1 for login method).3.Click “Settings” – “Network settings” – “Protocol Settings” – “IPv6”.view IPv6 address).43