C o n f i g u r a t i o n 4-61displays the current NetBIOS Server address and prompts you to enter anew NetBIOS Server IP address.4 Type the IP address of the new NetBIOS Server and press Enter. The IADdisplays the current Subnet Mask and prompts you to enter a new one.5 Type the new subnet mask and press Enter. The IAD displays the currentDomain name and prompts you to enter a new one.6 Type the new domain name and press Enter. The IAD displays the currentLease Time and prompts you to enter a new DHCP Lease Time.7 Type the new Lease Time value in seconds, and press Enter. The IADdisplays the NetBIOS Type Configuration menu.8 Type the option for the NetBIOS node type, and press Enter.9 Press Escape to return to the DHCP Server Configuration menu andcontinue configuring DHCP Server.Configure DHCP Address Range PoolYou must configure the DHCP address range pool to set the range of IPaddresses to return to the DHCP clients. All IP addresses must be on the samesubnet.To configure the DHCP address range pool, follow the steps below:1 Type “P” on the DHCP Server Configuration menu to select ConfigureDHCP Address Range Pool. The IAD displays the current High IP addressand prompts you to enter a new one.2 Type the new High IP address and press Enter. The IAD displays the currentLow IP address and prompts you to enter a new one.3 Type the new Low IP address and press Enter. The IAD displays the DHCPServer Configuration menu.Configure DHCP Client EntryYou can configure up to 10 static DHCP client entries by following the stepsbelow.1 Type “C” on the DHCP Server Configuration menu to configure DHCPClient Entry settings. The IAD displays the gateway address and promptsyou to enter the Client entry number to configure.2 Type the client entry number you’re configuring, and press Enter. The IADdisplays the current Mac address for this entry and prompts you to enter anew one.3 Type the MAC address in the template provided. The IAD displays thecurrent Host name and prompts you to enter a new one.4 Type the new host name and press Enter. The IAD displays an updateoption. Type “Y” to override the Lease Time default for this entry, “N” touse the default value, or proceed to Step 5.
