Parker EME Status values192-121102 N04 June 2008 427In this chapter you can read about:D/A-Monitor ......................................................................................................................427Status values....................................................................................................................427A list of the status values supports you in optimization and commissioning.Open the optimization function in the C3 ServoManager (double-click onoptimization in the tree)You will find the available status values in the lower right part of the window underselection (TAB) ”Status values”You can pull them into the oscilloscope (upper part of the left side) or into thestatus display (upper part of the right side) by the aid of the mouse (drag and drop).The status values are divided into 2 groups (user levels):standard: here you can find all important status valuesadvanced: advanced status values, require a better knowledgeThe user level can be changed in the optimization window (left hand side lower partunder selection (TAB) "optimization") with the following button.8.1 D/A-MonitorA part of the status values can be output via the D/A monitor channel 0 (X11/4) andchannel 1 (X11/3).In the following status list under D/A monitor output: possible /not possible).The reference for the output voltage can be entered individually in the referenceunit of the status value.Example: Output Object 2210.2: (actual position unfiltered)In order to get an output voltage of 10V at 3000min -1 , please enter 50Umd/s(=3000min -1) as "value of the signal at 10V".HintThe unit of measurement of the D/A monitor values differs from the unit ofmeasurement of the status values.8.2 Status valuesAdditional information on the topic of "status values" can be found in the onlinehelp of the device.8. Status valuesSwitching of theuser level
