3 – Windows 2000 Driver InstallationRemoving the DriverIS0053302-00 7 PRELIMINARY 3-5Q5. In the Install Hardware Device Drivers dialog box, select Display a list ofthe known device drivers for this device so that I can choose a specificdriver6. Click Next.7. In the Select a Device Drive dialog box, click Have Disk. Insert the QLogicdriver disk created in section 3.3.8. In the Install From Disk dialog box, type or browse the path to the QLogicdriver directory. For example:A:\Click OK.9. In the Upgrade Device Driver Wizard/Select a Device Driver dialog box, clickNext.10. In the Upgrade Device Driver Wizard/Start Device Driver Installation dialogbox, click Next.11. If the Digital Signature Not Found dialog box displays, click Yes.12. In the Upgrade Device Driver Wizard/Completing the Upgrade DeviceDriver Wizard dialog box, click Finish.13. The following message displays:Your hardware settings have changed. You must restart yourcomputer for these changes to take effect. Do you want torestart your computer now?Click Yes to restart the computer.After QLogic obtains a Digital Signature for the driver through the official WHQLprocess from Microsoft, the Digital Signature Not found dialog box will not display.(can this sentence, which is in other HBA user’s guides, be removed?)3.5Removing the DriverTo uninstall the QLA4010.SYS driver, power down your computer and remove theQLA4010/4010C HBA from your computer according to the manufacturer’sinstructions.NOTE: You do not have to use the Device Manager or the Hardware Wizard touninstall the QLA4010/4010C HBA. After you have removed theQLA4010/4010C HBA and restarted your computer, Windows 2000recognizes that it has been removed.