6 – SANsurfer Control iXConfiguring Targets6-30 PRELIMINARY IS0053302-00 7Q4. At the prompt, enter your password. The CHAP tabbed page displays (seefigure 6-25).Figure 6-25. CHAP Tabbed Page5. Select the Enable check box for the targets for which you want to use CHAP.6. Enter the initiator name and secret you want to use in the Initiator Name andInitiator Secret columns.7. CHAP is now enabled; the target will use CHAP to authenticate theQLA4010/4010C HBA. If you also want the QLA4010/4010C HBA (initiator) toauthenticate the target, perform the following steps:a. Select the Bidi check box of the target you want to configure.b. In the Target Table portion of the page, click the green plus sign (+) on theright. A blank row displays.c. Double-click the row in the Target Name column. Enter the target name,which can be a maximum of 256 ASCII characters. This name must beentered on the target side (Name) for bidirectional CHAP.d. Double-click the row in the Target Secret column. Enter the target secret,which can be a maximum of 100 ASCII characters. This target secret mustbe entered on the target side (Password) for bidirectional CHAP.e. Repeat steps a through d for each target you want to configure. If you wantto remove a target from the Target Table, click the row you want to remove,then click the minus sign (–) on the right.
