6 – SANsurfer Control iXGetting Started6-6 PRELIMINARY IS0053302-00 7Q6.3Getting StartedThis section includes the procedures for starting the SANsurfer Control iX GUI,exiting the SANsurfer Control iX GUI, and customizing the application options andpolicies.This section discusses:■ Starting the SANsurfer Control iX GUI (see section 6.3.1)■ SANsurfer Control iX main window (see section 6.3.2)■ Exiting the SANsurfer Control iX GUI (see section 6.3.3)■ Getting help (see section 6.3.4)■ Setting SANsurfer Control iX security (see section 6.3.5)6.3.1Starting SANsurfer Control iXThe SANsurfer Control iX GUI startup procedures differ depending upon theoperating system. This section discusses starting the SANsurfer HBA Manager GUIon the following systems:■ Windows 2000 (see section 6.3.1.1)■ Red Hat Linux (see section 6.3.1.2)6.3.1.1Starting SANsurfer Control iX on Windows 2000In Windows 2000, do one of the following to start the SANsurfer Control iXapplication. When done, the SANsurfer Control iX main window displays (seesection 6.3.2).■ Double-click the SANsurfer Control iX icon on your desktop (if the icon wascreated during installation) (see figure 6-7).Figure 6-7. SANsurfer Control iX Icon■ Click Start, select Programs, select the install group (the default is QLogicCorporation), select SANsurfer Control iX, then click SANsurfer Control iX.■ Click the Start button, click Run, and then do one of the following:❑ Type in the name of SANsurfer Control iX (SANsurfer Control iX.EXE orInstall.EXE? (conflicting review comments)), including all the paths. Click OK.❑ Click Browse, then select the program after finding it in the Browse dialogbox. Click Open.