6 – SANsurfer Control iXConfiguring the QLA4010/4010C HBAIS0053302-00 7 PRELIMINARY 6-23Q3. Configure the HBA as described in the following sections. When configurationis complete, click Save.After configuring the QLA4010/4010C, you can configure targets (see section 6.5),configure the firmware (see section 6.6), and run diagnostics (see section 6.7).6.4.1Setting the IP AddressThere are two ways to set the IP address, as described in the following sections:■ Automatically (through dynamic host configuration protocol (DHCP)) (seesection 6.4.1.1)■ Manually (see section 6.4.1.2)6.4.1.1Setting the IP Address AutomaticallyTo set the IP address automatically through DHCP, select the Obtain an IP addressautomatically (DHCP) radio button.6.4.1.2Setting the IP Address ManuallyTo set the IP address manually, perform the following steps:1. Select the Use the following IP address radio button.2. Enter the IP address.3. Enter the subnet mask.4. Enter the gateway.6.4.2Setting the DNS Server AddressThere are two ways to set the DNS server address, as described in the followingsections:■ Automatically (through dynamic host configuration protocol (DHCP)) (seesection 6.4.2.1)■ Manually (see section 6.4.2.2)6.4.2.1Setting the DNS Server Address AutomaticallyNOTE: You must select the Obtain an IP address automatically (DHCP) radiobutton to set the DNS server address automatically.