IS0053302-00 7 PRELIMINARY 6-1Section 6SANsurfer Control iX6.1IntroductionThe QLA4010/4010C HBA includes the SANsurfer Control iX GUI. The SANsurferControl iX GUI interface runs on Windows 2000 and Red Hat Linux operatingsystems. SANsurfer Control iX configures the QLA4010/4010C HBA that residesin the host PC and allows you to:■ Set the QLA4010/4010C HBA’s basic configuration (IP address, iSCSI name,etc.)■ Enter iSCSI target information (IP addresses of targets to which you want toconnect)■ Edit the target and firmware configuration parameters■ Read back useful QLA4010/4010C HBA and target information6.2Installing SANsurfer Control iX6.2.1Initial InstallationFollow these steps to install the SANsurfer Control iX GUI:1. Download SANsurfer Control iX from the QLogic web site:a. Locate SANsurfer Control iX on the QLogic web site (www.qlogic.com) andclick Download.b. When prompted Would you like to open the file or save it to yourcomputer?, click the Save button. Specify a temporary location on the harddisk and download the self-extracting file.2. Do one of the following to select and start the installation:❑ For a Windows 2000 system, locate the folder where you downloadedSANsurfer Control iX. Double-click the file name.