6 – SANsurfer Control iXConfiguring the Firmware6-36 PRELIMINARY IS0053302-00 7Q6.6.2Restoring the Factory DefaultsPerform the following steps to reset the firmware parameters to the factory defaults:1. Click the desired adapter in the HBA tree. By default, the HBA Options tabbedpage displays.2. Click the Firmware tab.3. Click Restore Factory Defaults. The defaults are displayed in the firmwareparameters table (see figure 6-26).6.6.3Firmware UpgradeIf you are receiving a QLA4010/4010C HBA for the first time, the current version offirmware is already loaded.If you are upgrading a QLA4010/4010C HBA, follow the instructions in this sectionto load the latest firmware from the QLogic web site. The HBA Information tab inSANsurfer Control iX displays the firmware version you are using.To upgrade the firmware, follow these steps:1. Locate the iSCSI firmware on the QLogic web site (www.qlogic.com) and clickDownload.2. When prompted Would you like to open the file or save it to yourcomputer?, click the Save button. Specify a temporary location on the harddisk and download the file.3. In the temporary directory, locate the file, qla4000fwxx.exe. Double-click thefile to extract it to a specified directory.4. Start SANsurfer Control iX: click Start, select Programs, select the install group(the default is QLogic Corporation), then click SANsurfer Control iX.5. Select your HBA.6. Click the HBA Options tab.7. Click the Firmware tab.8. Click the Select Firmware to Download button.
