6 – SANsurfer Control iXConfiguring TargetsIS0053302-00 7 PRELIMINARY 6-27QCAUTION! The iSCSI port number defaults to 3260. Do not change this numberunless required by the configured target.6.5.2Configuring Specific TargetsTo configure a specific iSCSI target, follow these steps:1. Start SANsurfer Control iX, select your host and QLA4010/4010C HBA, thenclick the Target Settings tab.2. Click green plus sign on the right-hand side of the screen (see figure 6-14).3. Double-click the IP Address column. Enter the IP address of the target to whichyou want to connect.4. Double-click the iSCSI Name column. Enter the iSCSI name of the target.5. If you want to enable the target, select the check box in the Enable Targetcolumn associated with the target. If this check box is not selected, the targetis visible, but not accessible, to the HBA.6. If you want to bind the target to the HBA (the Auto-bind Discovered Targetscheck box was not selected), select the box in the Bind column associated withthe target.7. Enter other targets as desired.8. If you want all of the targets to be restored when the HBA is reset, select theAuto-discover targets (Rediscover on Save) check box.9. If you want to change any of the configuration parameters, follow theinstructions in section 6.5.3.10. Do one of the following:a. Click Save. The QLA4010/4010C HBA does the following:❑ Resets (reboots the HBA only) if you have made changes to the firmwareconfiguration parameters in section 6.6.1.❑ Connects to the target❑ Makes these new targets available on the SANsurfer Control iX TargetSettings tabbed pageb. Right-click the target and select Login/Save Device. Enter your passwordat the prompt. The QLA4010 logs into (same as connects?) to the specifictarget and saves this configuration. Why would they do this instead of clickingSave?c. If you want to log out, then reconnect to the target, right-click the target andselect Logout/Reconnect. Enter your password at the prompt.