RCA L26HD32D Owner's Manual

Also see for EN-V L32HD32D: Specifications Specifications

15Setting the on-screenlanguageYou can choose from three different languages(English, French and Spanish) for the on-screendisplays.Select the language you prefer first, thenproceed with the other menu options.1 To turn on the TV, press POWER.(POWER indicator on the front of the unitchanges green. It may take approx. 10 secondsfor a picture to appear on screen.)2 Press TV/DVD to select TV mode.3 Press SETUP/TV MENU. The TV menu screenwill appear.4 Press ϳ or ϴ to select “Setup”, then press ϶ orENTER.5 Press ϳ or ϴ to select “Language”.Video Label >>BacklightAuto Shut Off OffReset >>16SetupClosed Caption >>Language English: Adjust: SelectNOTE:When you press SETUP/TV MENU first time afterpurchase this LCD TV, above screen will appearautomatically.•6 Press ϵ or ϶ to select the desired language:English, French (Français) or Spanish (Español).7 Press EXIT/CANCEL to return to the normalscreen.NOTE:If no buttons are pressed for more than about 60seconds, the menu screen will return to normaloperation automatically.Memorizing channelsThis TV is equipped with a channel memoryfeature which allows channels to skip up or downto the next channel set into memory, skippingover unwanted channels. Before selectingchannels, they must be programmed into theTV’s memory. To use this TV with an antenna, setthe Signal Type option to the Air mode. Whenshipped from the factory, this menu option is inthe Cable mode.Air/Cable selection1 Press SETUP/TV MENU in the TV mode. The TVmenu screen will appear.2 Press ϳ or ϴ to select “Channel”, then press ϶or ENTER.•3 Press ϳ or ϴ to select “Auto Ch Memory”, thenpress ϶ or ENTER.4 Press ϳ or ϴ to select “Signal Type”.5 Press ϵ or ϶ to select “Air” or “Cable”.Air - VHF/UHF channelsCable - CABLE TV channelsAutomatic Search StartAuto Ch MemorySignal Type Cable: Adjust: Select6 Press EXIT/CANCEL to return to the normalscreen.CABLE CHARTThe chart below is typical of many cable systemchannel allocations.NOTE:It may take a few seconds for a digital channelpicture to appear on screen after being selected.Automatic search1 Press SETUP/TV MENU in the TV mode. The TVmenu screen will appear.2 Press ϳ or ϴ to select “Channel”, then press ϶ orENTER.3 Press ϳ or ϴ to select “Auto Ch Memory”, thenpress ϶ or ENTER.4 Press ϳ or ϴ to select “Automatic Search”, thenpress ϶ or ENTER.Auto Ch MemorySignal Type CableDigital Channel Found : 0Analog Channel Found : 0: Select ENTER:CancelAutomatic Search Stop5 The TV will begin memorizing all the channelsavailable in your area.It may take from 15 minutes to 30 minutes tocomplete memorizing digital cable channels.Depending on the reception condition, a bardisplay may not advance for several minutes,please be patient.••51F0101A_eng.indd 15 3/5/08 5:05:52 PM