RCA L26HD32D Owner's Manual

Also see for EN-V L32HD32D: Specifications Specifications

38orConnections to other equipment (continued)To connect the TV/DVD to a camcorder, or a TV GameTo playback from a camcorder, connect the camcorder to the unit as shown.This unit can also be used as a display device for many video games. However, due to the wide variety ofsignals generated by these devices and subsequent hook-up variations required, they have not all beenincluded in the suggested connection diagrams. You’ll need to consult each component’s Owner’s Manual foradditional information.Rear of the unitAudio/Video cord(not supplied)To LINE 1 or LINE 2 VIDEO/AUDIO INTo Audio/Video OUTVGA cable (not supplied)To connect the TV/DVD to a PC (Personal Computer)Before you connect this TV/DVD to your PC, change the adjustment of your PC’s Resolution and Refresh rate(60 Hz).Connect one end of a (male to male) VGA cable to the video card of the computer and the other end to the VGAconnector PC MONITOR on the rear of the TV/DVD . Attach the connectors firmly with the screws on the plug. Incase of a Multimedia computer, connect the audio cord to the audio output of your Multimedia computer and tothe AUDIO connector of the PC/DVI AUDIO IN jack of the TV/DVD.Press INPUT SELECT on the remote control to select PC mode.Switch on the computer. The TV/DVD can operate as the computer monitor.Monitor Display modesMODE Resolution Refresh rateVGA 640x480 60HzVGA 720x400 70HzSVGA 800x600 60HzXGA 1024x768 60HzWXGA 1280x768 60HzWXGA 1280x720 60HzWXGA 1360x768 60HzTo return to normal modePress INPUT SELECT again.PC/DVIAUDIO INjackTo PC INNOTE:The on-screen displays will have a different appearance in PC mode than in TV mode.If there is no video signal from the PC when the unit is in PC mode, “No signal” will appear on the TV-screen.••Audio cord (not supplied)Rear of the unitTo connect an audio systemThis connection allows you to use an audio amplifier and external speakers, and adjust the audio level using theTV’s remote control.To control the audio, turn on the unit and the stereo amplifier, and turn off the unit’s built-in speakers (see“Turning off the built-in speakers” on page 24).Rear of the unitAmplifierTo Audio (L) Input To Audio (R) InputAudio cord (not supplied)NOTE:To hear sound when using anexternal audio amplifier, thevolume of both the unit and theamplifier must be set above 0(zero).For example, if the volume of theunit is set to 0, you will not beable to hear any sound, even ifthe volume of the amplifier is at itshighest level.•51F0101A_eng.indd 38 3/10/08 10:56:12 AM