RCA L26HD32D Owner's Manual

Also see for EN-V L32HD32D: Specifications Specifications

225 Press EXIT/CANCEL to return to the normalscreen.Setting the picture sizeYou can view 480i and 480p format programs in avariety of picture sizes— Natural, Cinema Wide1,Cinema Wide2, Cinema Wide3 and Full.Selecting the picture size1 Press SETUP/TV MENU in the TV mode. The TVmenu screen will appear.2 Press ϳ or ϴ to select “Picture”, then press ϶ orENTER.3 Press ϳ or ϴ to select “Picture Size”, then press϶ or ENTER to display Picture Size menu. Pressϳ/ϴ or corresponding Number buttons (0-4)to select the desired picture size, as describedbelow.Picture Size1.Cinema Wide12.Cinema Wide23.Cinema Wide3[0-4]:Select0.Natural4.FullNOTE:Selectable picture sizes may vary depending on theinput source or broadcast signal.Picture Size menu also can be displayed bypressing SCREEN SIZE on the remote control.••4 Press EXIT/CANCEL to return to the normalscreen.Natural picture sizeIn some cases, this image will display the size ofstandard 4:3 with a black side bar.Cinema Wide1 picture size (for 4:3 formatprograms)To fill the screen, the right and left edges areextended,however; the center of the picture remains near itsformer ratio.The top and bottom edges of the picture may behidden.Cinema Wide2 picture size (for letter boxprograms)The entire picture is uniformly enlarged—it isstretched the same amount both wider and taller(retains its original proportion).The top and bottom edges of the picture may behidden.A B C D E F G - - - - - - - - - - - - - - - -Cinema Wide3 picture size (for letter boxprograms with subtitles)To fill the width of the screen, it is extendedhorizontally. However; it is only slightly extended at thetop and the bottom.The top and bottom edges of the picture may behidden.A B C D E F G - - - - - - - - - - - - - - - - A B C D E F G - - - - - - - - - - - - - - - - - - - - - - - - - -Full picture size (for 16:9 source programs)Full will display the picture at the maximum size.NOTE:Some High Definition and/or Digital broadcasts maynot allow you to change the picture size.In HDMI or COMPONENT mode with a scanningrate of 720p or 1080i, only the Cinema Wide2 andFull picture size features are available.In PC Mode, only the Natural and Full picture sizefeatures are available. Additionally this feature willnot work when display mode is WXGA.In Cinema Wide2 picture size, some of the onscreen display items may be positioned off thevisible portion of the screen.Film ModeA smoother motion may be obtained by settingthe Film Mode to “On” when you view a DVD.1 Press SETUP/TV MENU in the TV mode. The TVmenu screen will appear.2 Press ϳ or ϴ to select “Picture”, then press ϶ orENTER.3 Press ϳ or ϴ to select “Film Mode”.Press ϵ or ϶ to select “On” or “Off”.••••51F0101A_eng.indd 22 3/5/08 5:05:57 PM