Chapter 5: USB Profiles95USB profile DescriptionTroubleshooting 3 Troubleshooting Profile 3• Mass Storage first• Keyboard and Mouse (Type 2)• USB bus speed limited tofull-speed (12 MBit/s)• Virtual CD-ROM and disk drivescannot be used simultaneouslyWARNING: USB enumeration willtrigger whenever Virtual Media isconnected or disconnected.Use Full Speed for VirtualMedia CIMUse Full Speed for Virtual Media CIMThis profile resembles the behavior ofthe original KX2 release with FullSpeed for Virtual Media CIM optionchecked. Useful for BIOS that cannothandle High Speed USB devices.Restrictions:• USB bus speed limited tofull-speed (12 MBit/s)Selecting Profiles for a KVM PortThe Dominion KX II comes with a set of USB profiles that you can assignto a KVM port based on the characteristics of the KVM target server itconnects to. You assign USB profiles to a KVM port in the DeviceSettings > Port Configuration > Port page in either the Dominion KX IIRemote or Local Console.It is the administrator that designates the profiles that are most likely tobe needed for a specific target. These profiles are then available forselection via MPC/VKC. If a profile has not been made available, youcan access any of the available profiles by selecting USB Profile > OtherProfiles.Assigning USB profiles to a KVM port makes those profiles available to auser when connected to a KVM target server. If required, the user canselect a USB profile from the USB Profile menu in VKC or MPC.For information about assigning USB profiles to a KVM port, seeConfiguring USB Profiles (Port Page) (on page 167).
