Chapter 12: Command Line Interface (CLI)212SSH Access from a UNIX/Linux WorkstationTo open an SSH session from a UNIX/Linux workstation and login as the user admin, enter the following command:ssh -l admin 192.168.30.222The Password prompt appears.See Logging In (on page 213).Note: Both IPv4 and IPv6 addresses are supported.Telnet Connection to the Dominion KX IIDue to the lack of security, user name, password and all traffic is inclear-text on the wire. Telnet access is disabled by default.Enabling TelnetIf you wish to use Telnet to access the Dominion KX II, first access theDominion KX II from the CLI or a browser.To enable Telnet:• Enable Telnet access in the Device Settings > Device Servicesmenu.Once Telnet access is enabled, you can use it to access the DominionKX II and set up the remaining parameters.Access Telnet from a Windows PCTo open a Telnet session from a Windows PC:1. Choose Startup > Run.2. Type Telnet in the Open text box.3. Click OK. The Telnet page opens.4. At the prompt enter the following command: Microsoft Telnet>open where is the Dominion KX II IPaddress.5. Press the Enter key. The following message appears: ConnectingTo ... The login as prompt appears.See Logging In (on page 213).Note: Both IPv4 and IPv6 addresses are supported.
