Regency LRI4E Owners & Installation Manual

Contents

26 | LRI4E / HRI4E Direct Vent Gas Insert|26installationLRI4E LOG SET INSTALLATION919-408 07.03.141. Seat Log 1 on the back left side indent in the burner. When Log isseated, grasp both ends of the Log and slide forward until Log 1 issnug against raised portions of burner.2. Identify corresponding pin locators on bottom of Log 2 and line upwith pins on burner- see below.3. Seat Log 3 into indent in burner as shown below.4. When seated, push Log 3 to the back as far as it will go withinindent. to prevent any carboning.Read the instructions below carefully and refer to the images. If the logs are broken do not use the unit until they are replaced. Brokenlogs can interfere with pilot operation.Improper positioning of the logs may create carbon build-up and can alter the unit's performance which is not covered under warranty.*For Touch Ups: Satin Black paint is included for burner, and Dark Brown Paint is included for log set,1 Rear Bottom Left Log2 Right Upright Log3 Middle Right Log Piece4 Front Left Log Piece5 Front Right Log6 Front Right Angled Log7 Top Back Log12346751233Log 3 push to the back of the indentLog 1 location on burnerLog 2 pin locator, line up with pins on burner1LRI4ELOG INSTALLATION