Regency LRI4E Owners & Installation Manual

Contents

LRI4E / HRI4E Direct Vent Gas Insert | 33|33installation3 SIDED LOW PROFILE FACEPLATE WITH SAFETY SCREEN INSTALLATION09.19.14919-416 1LRI4E / HRI4E / LRI6E / HRI6E3 SIDED LOW PROFILE FACEPLATE W/SAFETY SCREEN INSTALLATIONNote: Faceplate may be installed after the unit is in it's final position.3. Install Low Profile faceplate backing plate and secure to the unit with 6screws in locations shown below. Route power cord through the right sideof backing plate and install the grommet.Note: A mantel deflector may be installed to reduce the minimum mantel height.Refer to minimum clearances in the installation manual.If not installing the mantel deflector - proceed to step 3.1. Line up the mantel deflector (tabs to the back) with the Low Profilebacking plate.4. Install front faceplate by hooking back of front faceplate over lip edge onunit in locations shown below. Angle faceplate slightly to hook on, lowergently, bottom of faceplate will secure with magnets.Final InstallHooks on back offront faceplateHook onto unit to install2. Bend all 3 tabs 90º to secure the deflector to the top of the backing plate.The tabs should be flush with the underside of the top lip of the back plate.Top of backingplateMantel deflectorNOTE: To access the remote reciever pull lower portion of fron faceplatetowards you. The receiver will be located on the lower left side ofthe appliance.Power Cord