72Connecting and Using a Source Device22 Connecting and Using a Source Device2.5 Connecting the PC module (sold separately)2.5.1 MagicInfoTo use MagicInfo, a PC module must be connected to the product.For details on how to connect a PC module, refer to the PC module user manual. To change the MagicInfo settings, run "MagicinfoSetupWizard" on the desktop. For details on how to use MagicInfo, refer to the DVD provided with the PC module. The information in this section is subject to change without notice for quality improvement. If a problem occurs after the operating system provided with the PC module is replaced with anolder version, or another operating system is installed, or software that is not compatible with theprovided operating system is installed, users will not be able to benefit from technical support.They may be charged a fee for visits from service technicians. Product exchanges or refunds willalso not be available.Entering MagicInfo mode1 After installing and connecting the PC module to the product, turn on power for the product.2 Press SOURCE on the remote control, and select Plug In Module.3 Select the default application you want to run when MagicInfo starts.4 Enter the IP information.MagicInfo Setup Wizard - v.1.12Select Application - step 1MagicInfo Pro (LAN, WAN based version)MagicInfo-i Premium (Web-based version)Select Later< Back(B) Next(N) > Finish Cancel-
