763 Using MDC3 Using MDCMDC (Multiple Display Control) is an application that allows you to easily control multiple displaydevices simultaneously using a PC.3.1 Configuring Settings for Multi ControlMENU [ ] System Multi Control ENTER [ ]Assign an individual ID to your product.3.1.1 Configuring settings for Multi Control ID SetupAssign an ID to a set. (Range: 0~99)Press or to select a number, and press [ ]. ID InputEnter the ID number of the product connected to the input cable for input signal reception.Enter the number you want using the number buttons on the remote control. MDC ConnectionSelect a method to connect to MDC to receive the MDC signal. RS232C MDCCommunicate with MDC via the RS232C-stereo cable. RJ45 MDCCommunicate with MDC via the RJ45 cable. DisplayPort Daisy ChainTo display the [DP IN] video input through the [DP OUT] output port, select a device connectionmethod from Single Stream Transport (SST) and Multi Stream Transport (MST). Clone: In this Single Stream Transport (SST) output mode, the same screen output is displayedon two display devices connected.- If Clone is selected, the PC recognizes the two displays as a single monitor.- Clone mode is enabled if the input source is a digital input other than DisplayPort, suchas DVI, HDMI, MagicInfo, or PIM. Expand: In this Multi Stream Transport (MST) mode, a different screen output is displayed ontwo display devices connected.- If Expand is selected, the PC recognizes the two displays as separate monitors.- The mode functions only on a PC that supports DisplayPort 1.2 MST.- For Full HD resolution (1920x1080) displays, a maximum of four displays can beconnected.m
