Sanyo PLC-XC50 Owner's Manual

Also see for PLC-XC50 - 2600 Lumens: Manual Manual Specification sheet Owner's manual

Contents

4Basic Operationblack out → the captured image → normal → • • • • •Press the NO SHOW button on the remote control to blackout the image. To restore to normal, press the NO SHOWbutton again or press any other button. When a projectedimage is captured and set as "User" in the Logo selection(p.48), the screen changes each time you press the NOSHOW button as follows.NO SHOW buttonPress the AUTO SET button on the remote control tooperate the Auto setup function. For more detail, seepages 22, 28,46.AUTO SET buttonPress the D.ZOOM buttons on the remote control to zoomin and zoom out the images. For more detail, see page36.D ZOOM buttonsPress the P-TIMER button on the remote control. Thetimer display "00 : 00" appears on the screen and thetimer starts to count time (00 : 00 ~ 59 : 59).To stop the P-Timer, press the P-TIMER button. Pressthe P-TIMER button again, then the P-timer displaydisappears.P-TIMER buttonPress the IMAGE button on the remote control to selecta desired image level of the screen. For more detail, seepages 31 and 40.IMAGE buttonFor detail, see page 22.KEySTONE buttonLAMP CONTROL buttonPress the LAMP CONTROL button on the remote controlto select the lamp mode for changing the brightness of thescreen.Normal . . . normal brightnessAuto . . . . . brightness according with the input signalEco........... l o w e r b r i g h t n e s s r e d u c e s t h e l a m ppower consumption and extends thelamp life. Note:Lamp mode cannot be changed for a while afterturning on the projector. Lamp needs some time tostabilize after the power is turned on. Stored lampmode will be active after the lamp is stabilized.1 2+_Remote ControlD ZOOM buttonsNO SHOW buttonAUTO SET buttonNote:See the previous page for the otherbuttons.KEySTONE button(See p.22)POINT ▲▼ buttonsThe message disappears after 4 seconds.P-Timer displayLAMP CONTROL buttonP-TIMER buttonIMAGE buttonC