11Part Names and Functions!3 S-VIDEO INConnect the S-VIDEO output signal from videoequipment to this jack (p.20).!0 AUDIO INConnect the audio output signal from videoequipment connected to o or !3 to this jack. For amono audio signal (a single audio jack), connect itto the L (MONO) jack (p.20).!1 COMPUTER/COMPONENT AUDIO INConnect the audio output (stereo) signal from acomputer or video equipment connected to r ory to this jack (pp.19, 21).o VIDEO INConnect the composite video output signal to thisjack (p.20).r COMPUTER IN 2/COMPONENT INConnect the computer or component video (or RGBScart) output signal to this terminal (pp.19, 21).Use the supplied VGA cable or a Component-VGAcable commercially available. !2 AUDIO OUT (VARIABLE)Connect an external audio amplifier to this jack(pp.19–21).This terminal outputs sound from AUDIO IN terminal(!0 or !1).q R/C JACKWhen using the wired remote control, connect thewired remote control to this jack with a remotecontrol cable (not supplied).e SERVICE PORTThis jack is used to service the projector.y COMPUTER IN 1/DVI-IConnect computer output (Digital/Analog DVI-Itype) to this terminal (p.19). !4 USB (Series A)Connect the supplied USB Wireless LAN Adapter oroptionally available USB memory for Memoryviewer operation (refer to the owner’s manualsupplied with the optionally available USB memory).u LAN Connection TerminalConnect the LAN cable (refer to the owner’s manual“Network Set-up and Operation”).Rear Terminalq w e r t yiuo !0 !1w USB (Series B)In order to operate the computer with the remotecontrol and use the PAGE ed buttons on theremote control during a presentation, connect theUSB port of the computer to the USB terminal witha USB cable (not supplied) (pp.13, 19).t MONITOR OUTThis terminal can be used to output the incomingsignal from COMPUTER IN 2/COMPONENT INterminal to the other monitor (p.19).i ALARM buttonsUse these buttons when setting up the Alarmfunction (pp.58–59).!2 !3 !4