Sanyo PLC-XU110 Owner's Manual

Also see for PLC-XU110: Specifications Service manual

Contents

30Choose either Computer 1 (Analog) or Computer 2 bypressing the INPUT button on the top control or press theCOMPUTER button on the remote control.Before using these buttons, correct input source should beselected through Menu operation as described below.Press the MENU button to display the On-ScreenMenu. Use the Point 7 8 buttons to move the redframe pointer to the Input Menu icon.1 Input MenuUse the Point ed buttons to move the red arrowpointer to either Computer 1 (Analog) or Computer 2,and then press the SELECT button.2When selecting Computer 1 (Analog), RGB inputsource will be selected directly.When selecting Computer 2, the Source Select Menuappears. Move the pointer to RGB and then press theSELECT button.3Computer 1 (Analog)VideoComputer 2Input Source Selection (RGB: Computer 1 (Analog)/Computer 2 )Computer InputMove the pointer (redarrow) to Computer 1(Analog) and press theSELECT button.Input Menu iconCOMPUTER button✔Notes:•Computer 2 (COMPUTER IN 2/COMPONENT IN) can accept onlyRGB signal.•Wired, Wireless, and Memory viewer are for the Network function.See owner’s manual “Network Set-up and Operation” and owner’smanual of Memory viewer (optionally available).•When the Input Search function is set to “On1” or “On2”, theinput signal will be searched automatically (p.51).Move the pointer(red arrow) to RGB.Move the pointer (redarrow) to Computer 2and press the SELECTbutton.Input Menu iconComputer2WiredTop Control INPUT buttonComputer 1 (Digital)Remote ControlComputer 1 (Analog)Computer 2Computer 1 (Digital)Direct OperationMenu OperationInput Menu