14Part Names and FunctionsSpotlightPointer FunctionPointerLaser Light WindowSignal Emission IndicatorLaser Pointer FunctionLASER buttonPRESENTATION POINTERbuttonMENU buttonNO SHOW buttonThis remote control emits a laser beam from the laser light window. Press the LASER button to activate thelaser pointer. The signal emission indicator lights red and the red laser beam is emitted. If the LASER button ispressed for more than one minute or if it is released, the laser light goes off.The laser emitted is a Class II laser. Do not look into the laser light window or point the laser beam at yourselfor other people. The following is the caution label for the laser beam.CAUTION: Use of controls, adjustments or performance of procedures other than those specified herein mayresult in hazardous radiation exposure. Never look directly into the laser light window while a laseris emitted, otherwise eye damage may result.The caution label is put on the remote control.You can move the Spotlight or Pointer of the projector with the remote control to emphasize a part of theprojected image.Press and hold the MENU and NO SHOW buttons formore than 10 seconds to activate the Pointer function.(The Laser pointer has switched to the Pointer function.)1Press the LASER button on the remote control pointingtoward the projector. The Spotlight or Pointer isdisplayed on the screen with the LASER button lightinggreen. Then move the Spotlight or Pointer with thePRESENTATION POINTER button. If the LASER buttondoes not light green and continues to emit a laserbeam, try the abovementioned procedure until theLASER button lights green.2To clear the Spotlight or Pointer out the screen, pressthe LASER button pointing toward the projector and seeif the LASER button lighting is turned off.To switch to the Laser pointer again, press and hold theNO SHOW and MENU buttons for more than 10seconds or slide the RESET/ON/ALL-OFF switch to“RESET” and then to “ON”.When you reset the Pointer function, the remote controlcode will be reset, as well.3✔Note:•You can choose the size of Spotlight (Large/Middle/Small) and thepattern of Pointer (Arrow/Finger/Dot) in the Setting Menu. See“Pointer” on page 53.Press and hold the MENUand NO SHOW buttons formore than 10 seconds.PRESENTATION POINTERbuttonAfter the Laser pointer hasswitched to the Pointer, use theLASER button as the Pointerfunction ON-OFF switch. Press theLASER button pointing toward theprojector and see if it lights green.