65Maintenance and CleaningWhen the projection lamp of the projector reaches its end oflife, the Lamp replacement icon appears on the screen andLAMP REPLACE indicator lights yellow. Replace the lamp witha new one promptly. The timing when the LAMP REPLACEindicator should light is depending on the lamp mode.Follow these steps to replace the lamp.LampORDER REPLACEMENT LAMPReplacement lamp can be ordered through your dealer. When ordering a projection lamp, give the followinginformation to the dealer.● Model No. of your projector : PLC-XU110● Replacement Lamp Type No. : POA-LMP103(Service Parts No. 610 331 6345)For continued safety, replace with a lamp of thesame type. Do not drop a lamp or touch a glassbulb! The glass can shatter and may cause injury.Allow a projector to cool for at least 45 minutesbefore you open the Lamp cover. The inside ofthe projector can become very hot.CAUTIONScrewTurn off the projector and unplug the AC power cord.Let the projector cool for at least 45 minutes.Remove the two (2) screws that secure the lamp. Liftthe lamp out of the projector by using the handle.13Replace the lamp with a new one and secure the two(2) screws. Make sure that the lamp is set properly.Close the lamp cover.4Open the lamp cover.2Connect the AC power cord to the projector and turnon the projector.6 Reset the lamp counter.See “Resetting the Lamp Counter” on the next page.5Lamp ReplacementHandleScrewCAUTIONLamp CoverWARNING:TURN OFF THE UV LAMP BEFOREOPENING THE LAMP COVERTop ControlLAMP REPLACEindicatorLamp replacement iconPress here and pull upward.✔Note:•The Lamp replacement icon will not appear whenthe Display function is set to “Off” (p.48), during“Freeze” (p.28), or “No show” (p.29).