Sanyo PLV-Z700 Owner's Manual

17This projector uses nominal input voltages of 100 – 120 V or 200– 240 V AC and it automatically selects a correct input voltage. It isdesigned to work with the single-phase power systems having agrounded neutral conductor. To reduce the risk of electrical shock,do not plug into any other type of power system.If you are not sure of the type of power being supplied, consultyour authorized dealer or service station.Connect the projector with all peripheral equipment before turningit on.CAUTIONThe AC outlet must be near this equipment and must be easilyaccessible.Connecting the AC Power CordConnect the AC power cord (supplied) to theprojector.InstallationNOTE ON THE POWER CORDAC power cord must meet the requirements of the country where you use the projector.Confirm the AC plug type with the chart below and proper AC power cord must be used.If the supplied AC power cord does not match your AC outlet, contact your sales dealer.Projector side AC Outlet sideTo POWER CORDCONNECTOR on yourprojector.GroundTo the AC Outlet.(120 V AC)For Continental EuropeFor the U S A and Canada For the U KTo the AC Outlet.(200–240 V AC)To the AC Outlet.(200–240 V AC)For safety, unplug the AC power cord when the projector is notin use.When the projector is connected to an outlet with the ACpower cord and the Main On/Off switch is on, it is in stand-bymode and consumes a little electric power. Turn the Main On/Off switch off when the projector is not in use.✔Note: