Sanyo PLV-Z700 Owner's Manual

7AC Power Cord for the United Kingdom:This cord is already fitted with a moulded plug incorporating a fuse, the value of which is indicated on the pin face of the plug. Should thefuse need to be replaced, an ASTA approved BS 1362 fuse must be used of the same rating, marked thus ASA. If the fuse cover isdetachable, never use the plug with the cover omitted. If a replacement fuse cover is required, ensure it is of the same colour as thatvisible on the pin face of the plug (i.e. red or orange). Fuse covers are available from the Parts Department indicated in your UserInstructions.If the plug supplied is not suitable for your socket outlet, it should be cut off and destroyed.The end of the flexible cord should be suitably prepared and the correct plug fitted.WARNING: A PLUG WITH BARED FLEXIBLE CORD IS HAZARDOUS IF ENGAGED IN A LIVE SOCKETOUTLETThe Wires in this mains lead are coloured in accordance with the following code:Green-and-yellow ············ EarthBlue ································· NeutralBrown ······························ LiveAs the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying the terminals inyour plug proceed as follows:The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is marked by the letter E or by the safetyearth symbol or coloured green or green-and-yellow.The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black.The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red.WARNING: THIS APPARATUS MUST BE EARTHEDThe AC Power Cord supplied with this projector meets the requirement for use in the country you purchased it.AC Power Cord for the United States and Canada:AC Power Cord used in the United States and Canada is listed by the Underwriters Laboratories (UL) andcertified by the Canadian Standard Association (CSA).AC Power Cord has a grounding-type AC line plug. This is a safety feature to be sure that the plug will fit into thepower outlet. Do not try to defeat this safety feature. Should you be unable to insert the plug into the outlet,contact your electrician. GROUNDTHE SOCKET-OUTLET SHOULD BE INSTALLED NEAR THE EQUIPMENT AND EASILy ACCESSIBLEAC Power Cord RequirementFederal Communications Commission NoticeThis equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipmentgenerates, uses, and can radiate radio frequency energy. If it is not installed and used in accordance with the instructions, it may causeharmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. Ifthis equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off andon, the user is encouraged to try to correct the interference by one or more of the following measures:– Reorient or relocate the receiving antenna.– Increase the separation between the equipment and receiver.– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.– Consult the dealer or an experienced radio/TV technician for help.Use of shielded cable is required to comply with class B limits in Subpart B of Part 15 of FCC Rules.Do not make any changes or modifications to the equipment unless otherwise specified in the instructions. If such changes or modificationsshould be made, you could be required to stop operation of the equipment.Model Number(s) : PLV-Z700Trade Name : SanyoResponsible party : SANYO FISHER COMPANYAddress : 21605 Plummer Street, Chatsworth, California 91311Telephone No. : (818)998-7322Compliance