Sanyo PLV-Z700 Owner's Manual

28Press the Point ed buttons to select the Image adj. Menuand press the Point 8 or OK buttons to access the submenuitems.12 Use the Point ed buttons to select the desired item andpress the Point 8 or OK buttons to access the selected item.The adjustment bar is displayed.Image adj MenuPress the Point 7 button to decrease the contrast; press the Point8 button to increase the contrast (from -31 to +31).ContrastPress the Point 7 button to decrease the brightness; press thePoint 8 button to increase the brightness (from -31 to +31).BrightnessPress the Point 7 button to decrease the intensity of the color;press the Point 8 button to increase the intensity of the color(from -31 to +31).Use the Point 7 8 buttons to adjust the tint value to obtain aproper color balance (from -31 to +31).ColorTintUse the Point 7 8 buttons to select the desired Color temp. level(High2, High1, Default, Low1, or Low2). Default is based on thecurrently set image mode (p.27).Color tempIMAGE ADj buttonDirect OperationPress the IMAGE ADJ. button on the remote control to displaythe adjustment bar of Image adj. Menu items one at a time anddirectly adjust the selected item.Use the Point ed buttons to select the desired item and the Point7 8 buttons to adjust the setting. Press the MENU button afteradjusting.If you press the OK button after adjusting each item, it will enterthe main menu.Menu OperationRemote Control3 Use the Point 7 8 buttons to adjust the setting values andpress the OK button.Image mode can be adjusted for each input source and the adjustment is kept until the projector is turned off or the imagemode is changed.✔Note:• Tint cannot be selected when the video system is PAL, SECAM,PAL-M, or PAL-N in Video input or S-video input.• The Image adj. Menu cannot be operated without an input signal.Go on to the next page....Image AdjustmentImage Mode AdjustmentWhen Advanced menu is set to OffWhen Advanced menu is set to OnBrightness ➜ Contrast ➜ Color ➜ Tint ➜ Colortemp. ➜ Red ➜ Green ➜ Blue ➜ Sharpness ➜Lamp control ➜ Gamma ➜ Progressive ➜ Noisereduction ➜ Brightness ➜ • • • •Brightness ➜ Contrast ➜ Color ➜ Tint ➜ Colortemp. ➜ Red ➜ Green ➜ Blue ➜ Sharpness➜ Lamp control ➜ Gamma ➜ Progressive ➜Noise reduction ➜ Iris mode ➜ Iris range ➜Auto black stretch➜ Contrast enhancement ➜Transient improvement ➜ Color management ➜Dynamic gamma ➜ 3D-Y/C ➜ Custom gamma ➜Brightness ➜ • • • •✔Note:• 3D-Y/C may not appear depending on the inputsignal.✔Note:• Above image is an example of when the Imagemode is set to “Natural.” Each value variesdepending on the selected Image mode (p.27).