TASCAM DR-44WL 92 – Names and functions of partsIcon On/off statusBlank Key control function offKey control function onKey control function on (setting disabledstate)3 Reverb on/off status displayThis icon shows the reverb on/off status.Icon On/off statusBlank Reverb is offReverb is on (sound effects recording) INTMIC, EXT INReverb is on (SEND status) MIX4 Speaker output displaydisplayed: Speaker output onBlank: Speaker output off5 Phantom power supply displayBlank: No phantom power supply: 48V phantom power supplied: 24V phantom power supplied6 Power supply status messageWhen power is supplied from the batteries, the currentbattery level is displayed in bars ( , , ).When the battery level is low, the will flash and the powerwill be switched off (standby mode).When the dedicated AC adapter (GPE053B) supplied withthe product or USB bus power is used, appears.NOTEWhen attempting recording or other operations thatconsume large amount of power, a warning message ofBattery Low may pop-up.7 Recorder status messageThe recording status is indicated in the following icons:Indicator Detail8 Stop9 Pause7 Playback, Fast-forwardingm Fast-rewinding/ Skip forward to the beginning of the nextfile. Skip backward to the beginning of either thecurrent or preceding file8 Loop playback setting status displayDuring loop playback, the icon is displayed.9 Filename/song name displayWhen the 4CH mode is selected, the name or tag infor-mation of a file being played back is shown.The ID3 tag information is displayed instead when includedin the MP3 file.When there are multiple files in the 4CH mode, only theformat portion of each of the file names and the basicnumber of a recording file are displayed. When a single file isrecorded, its name is shown.When the MTR mode is selected, the name of an openedsong is shown.NOTEID3 tag information contains titles and artist names, whichcan be stored in MP3 files.0 Loop playback IN (starting) and OUT (ending) pointssetting statusThe IN (starting) and OUT (ending) points-setting state ofthe loop playback is shown.When the IN (starting) point is set, the icon appears at theset position on the playback position-displaying bar.The icon appears at the playback position on the barwhen the OUT (ending) point is set.q Playback position displayThe current playback position is shown by a bar. As playbackprogresses, the bar extends to the right.w Level meter guide displayThis is a level meter guide for adjusting the input and outputlevels. It is displayed at the “−12 dB” position of the scale.e Level meterThis meter displays the level of an input sound or that of aplayback sound.r File status displayThe file state is displayed in different ways, depending onthe type of a file to be played back.: Stereo file status: Status of two mono files: No filet Elapsed time displayDisplays the elapsed time (hours: minutes: seconds) of thecurrent file.y Remaining time displayDisplays the remaining time (hours: minutes: seconds) of thecurrent file.u Peak value displayed in decibel (dB)Displays the maximum playback level in decibel reading perset amount of time.Recording ScreenThe following recording screen is displayed in recording orrecording standby mode.Recording screen in the 4 CH mode