17 Engineer programming via the browserPanel status180Vanderbilt Installation & Configuration Manual A6V1027695901.05.2016Status of ATPs within ATS This table shows each ATP in the ATS. Foreach ATP, the table shows the ATPsequence number, the ATP name, thecommunications interface, ATP Status, Lastsuccessful transmission, Network Log, ATPLog and Test Call button.Network Log: Click this button to show thenetwork log.ATP Log: Shows a list of poll transmissions.Click the Refresh button to update the log.Click the Most Recent Last button to changethe viewing order. By default the most recentevent displays first.Manual Test button: Click this button to forcea test call. The Event is added to the eventqueue.17.6.7 System alerts1. Select Status > System Alerts.2. See tables below for further information.Alert Description of the system alert.Input The actual state of the alert that was detected on the panel (OK, Fault).Status The programmed status of the system alert, i.e. whether the alert has been isolated orinhibited. A status value of OK is displayed if the alert condition has not been disabled inany way (see page).Performable actionsRefresh Click this button to update the status of the system alerts.Restore Click this button to restore an alert on the panelInhibit Click this button to inhibit a fault condition. The inhibit operation will disable thatfault or zone for one arming period only.Inhibit operation is not available in Security EN 50131 Grade 3.Isolate Click this button to isolate the zone. Isolating a zone will de-activate that zone untilsuch time as the zone is explicitly de-isolated again. It is recommended that youexercise caution when isolating zones as those zones will not be active every timethe system is SET.!
