17 Engineer programming via the browserConfiguring Communications290Vanderbilt Installation & Configuration Manual A6V1027695901.05.20161 - 9 toZone ID 101 - 109, enter1 and9. Thequantity of addresses in the range must be equalto the quantity of addresses defined in the fieldRemap Event Address below.then Remap SIA Event Code to BA Remap the default SIA code to a customised SIAcode.and Remap Contact ID Event Code / Qualifier to Remap the default CID Event Code / Qualifier to acustomised CID Event Code / Qualifier.and Remap Event Address to Enter the new range of addresses, for example, ifyou are remappingZone ID 1 - 9 toZone ID 101 -109, enter101 and 109.17.10.2.7 Configuring Command ProfilesThe command profile defines the commands that are allowed on an ATS. Thisprofile determines how a CMS can control a panel. The default command profiledoes not support video verification.NOTICETo quickly create a new command profile, go to Communications - FlexC -Command Profiles. In the Command Profiles table, select a command profile andclick the edit button (blue pencil), Scroll to the bottom of the screen and clickReplicate. You can now make the changes you require. To add a command profile step by step, go to Communications - FlexC -Command Profiles. Click Add.
