Engineer programming via the browser 17Using the Fast Programmer311Vanderbilt Installation & Configuration Manual A6V1027695901.05.2016System Configuration FileThe following options are available to manage the system configuration file:Download Downloads a configuration file from the controller.Note: If an error message appears after clicking the download button, proceed asfollows:1. Select Internet Options in the Tools menu.2. Select the Advanced tab.3. Mark the checkbox Do not save encrypted pages to disk.4. Click Apply.5. Click OK.6. Click Download again.When downloading a configuration file, the configuration settings are stored in a .cfgfile. This file can then be uploaded to other controllers to avoid lengthy programmingprocedures.Upload Uploads a configuration file to the controller.Backup Stores a backup copy of the current configuration to flash.Restore Restores a backup copy of the current configuration from flash.Users DataThe following options are available to manage users data:Download Click the button to Download the users data from the panel. A dialog boxasks you where you would like the save the users.csv file.Upload Click the Browse button to Upload users data to the panel. This must be a.csv file format.17.12 Using the Fast ProgrammerThe SPC Fast Programmer is a portable storage device that provides the engineerwith the ability to upload and download configuration files in a quick and convenientmanner. The Fast Programmer has two interfaces located on opposite ends of thedevice:SPC controller interfaceThis 10-pin serial interface is located at the top of the Fast Programmer andconnects directly to the Fast Programmer interface on the controller board. Onceconnected, the engineer can upload and download files directly from the FastProgrammer via the browser and keypad programming tools.PC USB interfaceThis USB interface is located at the bottom of the Fast Programmer and connectsdirectly to the USB interface on a PC. Configuration and other files can be only becopied between the PC and the Fast Programmer using the SPC Pro programmingtool.
