Engineer programming via the browser 17Configuration255Vanderbilt Installation & Configuration Manual A6V1027695901.05.201617.9.7 Change own PINTo change a PIN, see Changing Engineer PIN and web password [➙ 194].17.9.8 Configuring advanced settings17.9.8.1 TriggersA trigger is a system state (e.g. zone closing / time / system event (alarm) etc.) thatcan be used as inputs to the Cause & Effects. The triggers can be logicallyassigned together using the logical operators and / or to create user outputs. Thesystem supports up to a maximum of 1024 triggers across all its Cause & Effectssystem.1. Select Configuration > Advanced > Triggers. The following window will be displayed.2. Configure the fields as described in the table below.Trigger System generated number for new trigger.Trigger will only become active if one of the 2 optional steps (calendar/timelimitation) is configuredDescription Enter a text description for the triggerCalendar Select a calendar, if required. If selected, the trigger will only be in effect duringthis calendar period. See page [➙ 251].Active Time/Timer Enter the number of seconds that the trigger conditions must be true before thetrigger will activateTime limited Select a time period between 00:00 and 24:00 during which the trigger will onlybe in effect. The Start time is inclusive, the end time is exclusive.Note: This parameter delays a trigger transition from ON to OFF only; fromOFF to ON is immediate.Trigger conditions The trigger is ON if the following conditions are satisfied (i.e. a logical ANDoperation is performed):Zone – the trigger is ON if the configured zone is in one of the following states -open, closed, short or disconnected.Door – the trigger is ON if the any of the following door options are configured;Entry granted, Entry denied, Exit granted, Exit denied, Door open too long,Door left open, Door forced open, Door normal, Door Locked, Door unlockedSystem - the trigger is on if the system output is in the configured state, whichcan be on or off. Possible system outputs are “External Bell”, “Alarm”, etc.Area - the trigger is ON if the area output is in an ON or OFF state. Possible
