Walker H37i Operator's Manual

Also see for H37i: Operator's manual Operator's manual Operator's manual

Safety Instructions H37i16SAFETY, CONTROL, AND INSTRUCTION DECALSSafety, Control, and Instruction Decals are installed on the machine;if any are missing, illegible, or damaged, a replacement should be ordered and installed beforeputting the machine into operation. The Decal Part Number is listed below and in the Parts Manual.Location: Right FenderPart Number: 2802-41. Warning – do not operate the machine withouta deck or other implement attached.2. Forward Speed Control● Move lever forward to increase speed;back to stop.3. Body Tilt Latch● Raise lever to release.● Lift at back of body to raise.4. Warning – do not engage PTO clutch withPTO shaft disconnected.5. PTO Clutch Lever● Move lever forward to engage PTO clutch;back to disengage.1. Warning – roll-over/crushing hazard.● Do not operate the machine on steepslopes or near drop-offs.● Avoid quick and/or sharp turns whenoperating on slopes.2. During normal operation always keep theROPS locked fully upright and use the seatbelt.3. Never use the seat belt if the ROPS is notlocked fully upright.4. Do not operate the machine on slopes if theROPS is not locked fully upright.5. Do not remove the ROPS.Location: ROPS Roll Bar (If Equipped)Part Number: 5685-32.3.1.4.5.5685-32.3.4.5.1.