MAKING COPIES 3–2 DOCUCOLOR 12 USER GUIDE1234567Power on and offSwitching the power offPress the Power Switch to the Off position toswitch the copier/printer off, as in Figure 1. TheTouch Screen will go dark.Allow the copier/printer to remain off forapproximately 30 seconds if you will be switchingit on again immediately.Switching the power onPress the Power Switch to the On position toswitch the copier/printer on. A message willdisplay asking you to wait.After the Power Switch is pressed to On, thecopier/printer takes approximately eight minutesto come to a Ready to Make Copies condition.The copier/printer produces colour copies at a rateof approximately twelve copies per minute,depending on the paper size and the feedingorientation of the paper.NOTE: The copier/printer starts automaticallyafter it comes to the Ready state if the Start buttonis pressed during warm-up. A message displays toindicate that the automatic start feature isactivated. Press the Stop button to cancel theautomatic start feature.CAUTION: The Fuser Roll remains in a cammed-up position if power to the copier/printer isinterrupted while the copier/printer is in use. If theFuser Roll remains in the cammed-up position fora prolonged period of time, the Fuser Roll can bedamaged and copy quality defects can occur. Toprevent any damage, the copier/printer should bepowered on and a copy made as soon as thepower is restored. The Fuser Roll will not bereleased from the cammed-up position until thepower is restored, the Power Switch is in the Onposition, and the Start button is pressed again.Figure 1: Power Switch - Off Position
