Using logical processing3-54 Using LCDS Print Description LanguageIn this mode, you can use the PRINT parameter to print thedelimiter (or the delimiter packet) and to select the outputdestination of this delimiter page: BIN, TRAY, or BOTH. Theoption BOTH delivers the page to the sample tray and to theoutput tray.The delimiter page, when printed, is output as part of thesubsequent report. All of the printing parameters selected in theJDL remain in effect during report delimiter printing exceptCARRIAGE CONTROL, which is ignored; the carriage control isreplaced by a Print and Space 1 line control.If DJDE records exist within the delimiter packet or immediatelyfollowing, they are included on the delimiter page.NondelimitermodeIf DELIMITER=NO is coded (Nondelimiter mode), a single recordseparates one report from the next. After satisfying the TESTcriteria, this record is considered part of the subsequent report.In this mode, the PRINT parameter is not available. Therefore,the delimiter is not printed on a special page.Delimiter on accounting pageYou may include part of the first record of a report on theaccounting page. This command is selected by coding theACCTINFO parameter, which is normally used to print part of thefirst (or only) RSTACK record.The ACCTINFO field is captured from the first record of thereport, even if that record does not satisfy the RSTACK test.Thus, the ACCTINFO data is captured even for a report(boundary) that was not detected by an RSTACK test.Status displayYou can display a subfield of the first record in a report when youdisplay job status on the user interface screen. You select thiscommand by coding the HRPTNA or HJOBNO parameter.Note that HJOBNO is not an RSTACK parameter and must becoded in the BANNER command.
