Using Dynamic Job Descriptor Entries (DJDEs)5-72 Using LCDS Print Description LanguageFor example, if the initial TOF and BOF values are 2 for everyjob, a page transition occurs every time a data record isprocessed because the TOF and BOF have the same value.If a TOF DJDE specifying a value of 1 is processed and thepage transition has already occurred, the TOF DJDE value istoo late and does not take effect until the next page transition.• The value option is defined the same as in the VFUcommand, described in the “Specifying print formatparameters” chapter.• If the value specified in the TOF DJDE is greater than orequal to the BOF (Bottom Of Form) value, the TOF value isset to 1.TRANS DJDESpecifies whether or not transparencies are used in the print job.Type Page orientedSyntax TRANS = {YES | NO}OptionsTRANS DJDE: points to note• The TRANS DJDE is used to force parameters whentransparencies are used and to minimize paper jams. IfTRANS=YES is specified, the following parameters areforced:– DUPLEX=NO– ACCT=TRAY– BFORM is ignored.– For the RPAGE command, the NUBACK parameter isforced to NUFRONT.Table 5-62. TRANS DJDE options and definitionsOption DefinitionYES Specifies that transparencies are used in the print job.NO Specifies that transparencies are not used in the print job.
