Specifying print format parameters4-80 Using LCDS Print Description LanguageOUTPUT STAPLEparameter: pointsto note• The STAPLE command must be specified in the initial JDL/JDE, or the JDL/JDE DJDE record must be the first recordprocessed. If there is a banner page in front of the JDL/JDEDJDE record, the STAPLE command is ignored.• If the NTO1=YES and STAPLE=YES parameters arespecified, the system overrides NTO1=YES with NTO1=NOand places an error message in the listing file when the JSLis compiled.• Individual sheets cannot be offset when they are coded in theJSL. To maintain consistent face-up orientation while stitchedand unstitched jobs are delivered to the stacker, you mayprint unstitched sets N-to-1, provided that the system doesnot encounter the override conditions that have been defined.• DP 75/90 systems: Jobs greater than 50 pages are notstapled. The default behavior is to fault the job, with no errormessage displayed. If you want the job to print without anyfinishing, do the following in the Overprint Finishing section ofthe Finishing window:1. Select [Print Job Unfinished].2. Select [Check Set–Size] before Printing.OUTPUT STOCKSIdentifies the stockset and its associated stocks that will be usedfor a report. This stockset file (STOCKSETNAME.STK) musthave been created previously via compilation of a JSL and mustcurrently be stored in the “lcds” resource folder.Syntax OUTPUT STOCKS = stocksetnameOptionsDefault No default.Table 4-75. OUTPUT STOCKS parameter options and definitionsOption Definitionstocksetname Specifies the stockset to be used for the job.
