Using Dynamic Job Descriptor Entries (DJDEs)5-52 Using LCDS Print Description LanguageLOGO DJDE: points to note• Any logos specified in a selected JDE (the JDE that wasspecified in the JDE DJDE) replace those from the originalJDE. If none are specified in the selected JDE, logos from theoriginal JDE are canceled.• If the logo that is specified in the Initial JDE is not found, thejob aborts and an error message is displayed. If a logo that isspecified after the start of the job is not found, the systemresponse is determined by the specifications in theABNORMAL ERROR parameter.• The HERE keyword must be included whenever the VADJ orHADJ options are coded. Otherwise, a syntax error occurs.• If inks are used:– If one inkref in the list is omitted, commas must be usedas place holders to maintain the relative positioning of theremaining ink references.– If more than two ink references are specified, theadditional ink references are ignored.LPI DJDESpecifies the values for the vertical spacing between subsequentlines.Type Record orientedSyntax LPI = {(linespacing [units], DEFAULT) | (linespacing [units],lineno, (...))}OptionsTable 5-42. LPI DJDE options and definitionsOption Definitionlinespacing lines per inchSpecifies the line spacing value. May be measured in:units Unit of measure for the amount of vertical line space. The options are:• LPI (lines per inch)• DOTS• XDOTS (600 dpi)The default unit is LPI.
