C o n t r o l P a n e l M e s s a g e sC h a p t e r 6 : T r o u b l e s h o o t i n g v 6-25ResetToSave Or * A setting will not take effect until a Reset is performed.ACTION: Perform a Reset or press Enter to continue without the settingtaking effect.Temp Font/Macro The printer was busy processing PCL data from a host system but the job was notcompleted since temporary fonts and macros were not deleted. The last pagetimeout has expired.This message appears until:• Another print job is received.• The Port Timeout expires and Auto Job End is On.ACTION: None.Test PrintPrinting...A Test Print is being printed (for use by service technicians).The message clears once the printing is completed.ACTION: None.Token Ring Fail The Token Ring card (XNIC-T’RING) has failed and cannot be used.ACTION: Press Enter to allow the printer to continue as if the Token Ringcard were not installed. This error is not subject to Auto Continue.Print a Configuration Sheet. If the sheet does not show Token Ring aspresent, contact your dealer or Xerox/Rank Xerox.Toner Low Toner is getting low in the EP (print) cartridge, but printing will continue withoutinterruption.ACTION: Replace the EP cartridge as soon as possible.Tray Jam-Open All TraysPaper has misfed at printer startup. The message alternates with:Open Front CoverRemove Jam SheetACTION: See “Misfeed Jam at Startup” (page 6-36).Turn Power OffThen OnA fatal disk error has occurred.ACTION: Power OFF the printer, then ON.Table 6.2 Control Panel messages (continued)Message Description/Corrective ActionTable 6.2 Page 20 of 22hapter6.frm Page 25 Friday, July 11, 1997 8:20 PM