M a i l b o x / C o l l a t o rC-46 v D o c u P r i n t 4 5 1 7 / 4 5 1 7 m p U s e r G u i d e7 Attach the power cords.A Plug one end of the short (60 cm/2 foot)Mailbox/Collator cord (1) into the ACreceptacle on the printer, and the otherend into the lower AC receptacle onthe Mailbox/Collator.B Plug one end of the printer powercord (2) into the upper AC powerreceptacle on the Mailbox/Collator, andthe other end into the wall.8 Power ON the Mailbox/Collator (1) first,and then power ON the printer.This is the proper sequence toalways use when restoring power tothe system.After warming up for a few minutes, theControl Panel displays the followingmessage:OnlineReadyIf any other message is displayed, seeTable 6.2 starting on page 6-6.9 Print a Configuration Sheet and checkthat the Mailbox/Collator appears in the“Installed Options” section. If not,remove it as per Steps 1 to 3 onpage C-47, then repeat Steps 5 to 9 of thisprocedure.NoteKeep the original packaging material should you ever need toremove the option.hapterc.frm Page 46 Friday, July 11, 1997 9:25 PM
