Xerox DocuPrint 4517 User Manual

Contents

C o n t r o l P a n e l O p t i o n sD-16 v D o c u P r i n t 4 5 1 7 / 4 5 1 7 m p U s e r G u i d ePCL Emulat MenuMain MenuInvokes the PCL Emulat Menu.PCL Font ListTest MenuPrints a complete list of all PCL fonts currently available in the printer. Printing is onthe paper size and from the default source as per Source Mapping specified in thePCL Emulat Menu.Perform EnhanceSystem MenuOffOn*Prints jobs with maximum throughput. However, when Page Protection is set toOff, some complex jobs may not print successfully with minimum memory. If thisoccurs, set Perform Enhance to Off. If the job still does not print, then setPage Protection to On (for PostScript) or to the appropriate paper size (forPCL emulation), and install the required system memory.When Perform Enhance is set to Off, the system will optimize job processing inminimal memory, but throughput will be reduced.PitchPCL Emulat Menu0.44 - 99.99 by .01 steps10.00* c.p.i.Specifies the number of characters per inch (cpi) for the font represented byFont Number (page D-8).It appears only when the Font Number setting (page D-8) specifies a scalablefixed pitch font.Up increments pitch by .01 cpi, from .44 to 99.99 cpi.Down decrements by .01 cpi.Hold Up or Down for approximately two seconds and Pitch scrolls inincrements of 1.Point SizePCL Emulat Menu4.00 - 999.75 by .25 steps12.00* pointsSpecifies the point size (a measurement for type height, 1 point equals 0.351 mmor approximately 1/72 inch) for the font represented by Font Number (page D-8).Appears only when the Font Number setting specifies a scalable proportionalspaced font, such as Times New Roman.Up increments point size by .25 points, from 4.0 to 999.75 points.Down decrements by .25 points.Hold Up or Down for approximately two seconds and Point Size scrollsin increments of 1 point.Table D.1 Control Panel menu options, settings, and descriptions (continued)Menu Option,Location(s),Setting(s)DescriptionTable D.1 Page 14 of 21hapterd.frm Page 16 Friday, July 11, 1997 10:19 PM