5 0 0 - s h e e t P a p e r D e c k a n d C a s s e t t eA p p e n d i x C : I n s t a l l i n g a n d R e m o v i n g P r i n t e r O p t i o n s v C-316 If two Paper Decks are installed, detach the Paper Decks from each other. Otherwise,continue to Step 7.A Remove the joint tabs joining the two Paper Decks.B Disconnect the plug of the bottom Paper Deck from the receptacle of the upper PaperDeck.Be sure to keep the joint tabs. You will need them to reinstall the Paper Deck(s).7 Replace the power and interface cords, and power ON the printer.After warming up for a few minutes, the Control Panel displays the following message:OnlineReadyIf any other message is displayed, see Table 6.2 starting on page 6-6.8 Press Online , then Reset and you see:Reset MenuReset Printer9 Press Down and you see:Reset MenuReset Menus10 Press Enter and the message display changes to:Reset MenusPlease Wait...This message displays while the printer resets the Source Mapping (PCL Menu) and TraySwitching (PostScript Menu) settings to factory defaults.When the reset is finished, the display changes to:OnlineReadyIf any other message is displayed, see Table 6.2 starting on page 6-6.hapterc.frm Page 31 Friday, July 11, 1997 9:19 PM
