MAINTENANCE TASKSXEROX DOCUPRINT 96/DOCUPRINT 96MX LPS OPERATOR GUIDE 10-21Cleaning the 1/4 inch cartridge tape driveThe 1/4 inch cartridge tape drive heads should be cleaned at leastonce a week. If you use the drive for eight hours or more per day,then you should clean the drive daily. The process is simple andrequires very little time.Step 1. If there is a cartridge in the tape drive, remove it.Step 2. Insert the cleaning cartridge into the tape drive and close the door.Cleaning begins automatically once the cartridge is inserted.Step 3. Allow the tape to run for approximately 30 seconds, then remove it.Note: Replace the foam pad on the cleaning cartridge after it hasbeen used three times. The cleaning cartridge itself can be usedapproximately 100 times.Using the custom transfer assist bladeThe transfer assist blade in the Xerox DocuPrint 96/DocuPrint 96MXLPS assures good print quality for your jobs. A kit is availableallowing you to customize a transfer assist blade for use with non-standard paper size.Note: Use the custom transfer assist blade on all 4635MX systemsrunning non-standard paper sizes to ensure acceptable MICR linequality.When not to use the custom transfer assist bladeYou cannot use the custom transfer assist blade for print jobs thatuse more than one paper size. In addition, the following range ofpaper lengths cannot use the custom blade:• In U.S. markets— 11.1 to 11.4 inches/282 to 290 mm— 11.8 to 12.1 inches/300 to 307 mm— 13 to 13.5 inches/330 to 343 mm.• In non-U.S. markets— 11.1 inches to 11.4 inches/282 to 290 mm— 11.8 inches to 12.1 inches/300 to 307 mm.Note: With these paper sizes, transfer efficiency may be reduced.
